Vectric Customer

Is it too much time/work to surface the material to constant thickness? What if you just surfaced the perimenter areas that will take the magnets? Thank you for bringing that up. On one of my cases, I mill off about half the thickness of the wood before drilling my pockets and holes for the magnets...

Hello everyone!, I'm beginning to to manufacture some products which are basically small cases. The cases are machined from bamboo and held together by magnets. I drill 4 holes around the perimeter to mount the magnets flush with the surface. My work is clamped down on the left and right sides to se...

My initial thought is that you could use a bull nose bit on an appropriately offset vector inside your pocket. I was considering something similar to that. I also just noticed that the vcarve/engraving toolpath (using a flat area clearance tool) might be appropriate. It definitely removes the harsh...

Hello Vectric Forum, Question: How can I create a pocket with smooth/ramped inside corners/edges? The only way I have been able to cut my pockets is with 90 degree angles on the inside edges. Is there a way to cut the pocket with inside edges that gradually/smoothly come down from the top face to th...