Vectric Customer

Within the past 2-3 years viewing different topics on the forum, I found one that might be interesting to cut out. It was a hand held item that could hold snacks to include three distinct recessed areas for a soft drink can, wine glass, and a plastic cup. Recently looked through the forum not rememb...

For ease of use and simplicity at least for myself I've used a Mac Desktop since the late 80s. For designing I utilize Mac Bootcamp and Windows v10 without any issues. For the shop I purchased a low cost Windows machine to run my files.

I'm utilizing a Shopbot Desktop CNC with V10.5, several years ago if I my memory is correct a video was(is) available illustrating the process of placing text on a banner that is positioned at an angle. The video was a pair of wedding bands with the wedding date placed on the banner.

I use a Shopbot Desktop CNC utilizing Aspire 10.5. The dimensions of the slab follows. 13 inches wide with a tapered live edge of 2 inches on both sides width of the working area is 9 inches. I plan on using a 2 inch offset to take into account the live edge. Am I going in the correct direction or i...

Shopbot didn’t display an type of error message. It went to line 171 and stopped.

Presently own a 24 X 18 Shopbot using Aspire 10.5 Recently loaded a file completed all the parameters (zero the bit), began the cut at line 152 the spindle came to a complete stop I was unable to raise the head allowing the bit to return to zero. I attempted a second cut and the same occurrence happ...

Figured out what I did wrong with the pocket hole stepped down in tool size problem eliminated. Thanks for everyone's advice.

Need help with step by step instructions on how to post a tool path file on the forum. I attempting to produce a simple project the letter "E" I design, set the parameters, and proceed to save the file. The tool begins the cut at approximately line 50 - 70 everything stops. What am I doing wrong?

I haven't uploaded a file before normally I'll ask a question then I'll receive a response. You may need to digress to paper and crayon because at times my wife says I'm electronically challenged.

I created a circle .160 attempted to use a .125 to pocket the hole. Received an error message which read tool will not pocket hole using selected tool. I'm at a loss any ideas or solutions?

Thanks for the input I'll try the process later.

From Design and Make I've downloaded a file named Compass 1. If possible does a procedure exist where a portion of Compass 1 could be modified, or has the owner of the file made it to where nothing can be changed?

Request an individual to validate a theory I have. Presently, I’m using Aspire 10.5 however the computer required shop time I have another computer which has Aspire 9.5. If my design is created in 10.5 can 9.5 be used?

Adrian: I emailed them the CRV files however, they are requesting strictly the tool path for the file. What is the process to accommodate what they are asking for? I went to the tool path clicked on save tool path went to save then emailed the file they responded, stating they didn't receive the too...

What is the process if one exists to send a tool-path via email for review by an individual. If a process does exist request the steps be simplified for me as I've never done an email before with just the tool-paths. I sent them the CRV file however, they are requesting the tool path unless that's i...