Search found 5 matches
- Tue Oct 04, 2022 6:26 pm
- Forum: Gadgets - General
- Topic: Trim Objects Outside Boundary
- Replies: 10
- Views: 5268
Trim Objects Outside Boundary
I like this command, both for inside and outside boundary clearing. It's a jewel, except for one thing. It's S L O W I mean, really slow. Clearly, the complexity of the graphic is key, but there doesn't seem to be an inflection point where simple ends and complexity starts. In other words, sometimes...
- Sat Aug 20, 2022 10:45 pm
- Forum: Gadgets - General
- Topic: Box Creator overlapping models
- Replies: 2
- Views: 3139
Box Creator overlapping models
I use the Box Creator a lot and every single time I generate a box, it gets inserted into my drawing as two drawings, one on top of the other. My typical operational flow is as follows: 1. Start the Gadget, specify the parameters, and click OK 2. The resultant objects that were created by the gadget...
- Thu Aug 04, 2022 6:48 pm
- Forum: VCarve - General
- Topic: Rotate 90 button
- Replies: 13
- Views: 1896
Rotate 90 button
It would be nice if the interface had a "Rotate 90 degrees" button. Even better, one for CW and one for CCW.
- Mon Aug 16, 2021 7:49 pm
- Forum: VCarve - General
- Topic: How to draw a spiral?
- Replies: 1
- Views: 1109
How to draw a spiral?
Illustrator has a spiral vector drawing tool. It would be nice to have in Vectric. I faked a spiral by creating a set of concentric circles and dividing them in half vertically. Then, The right half was moved down by one semi-circle. This created two interwoven spirals, of which one could be selecte...
- Mon Aug 16, 2021 7:35 pm
- Forum: Laser Module - General
- Topic: Ruida Controllers?
- Replies: 1
- Views: 7495
Ruida Controllers?
I've read here that Ruida controllers aren't supported by Vectric. That's a shame because they are very capable DSP-based controllers. Could someone enlighten us as to why they are so difficult to support? I have a Laguna 150W CO2 laser that does a great job with its Ruida controller, however, the o...