Search found 4 matches
- Sun Jan 02, 2022 7:02 pm
- Forum: VCarve - General
- Topic: Unable to Save Toolpaths
- Replies: 7
- Views: 3029
Unable to Save Toolpaths
I just updated to version 11.009. Since then I am unable to Save my Toolpaths. Each time I try to save a toolpath I get the message shown below. Any help or guidance would be appreciated. NOTE: I have made sure that the folders are not read only. The folder is not open anywhere else. I have more tha...
- Tue Jul 06, 2021 9:09 pm
- Forum: Aspire - General
- Topic: VERSION 11 - COMING SOON
- Replies: 136
- Views: 53092
Re: VERSION 11 - COMING SOON
I'm an idiot today - I see VII and think roman numerals and what is 7? Not so fast. I saw "vee-eye-eye" and had to think twice that was Roman nuumerals. Had it been a lower case "v" I might have been OK. Here's a case where the typeface designer shouldn't have allowed the number one and the captial...
- Tue Jul 06, 2021 8:59 pm
- Forum: VCarve - General
- Topic: "Add New Texture" for Materials on Job Setup
- Replies: 5
- Views: 1431
"Add New Texture" for Materials on Job Setup
On the Job Setup dialog box, at the very bottom, the appearance (material type) can be selected. In the selection choices there is a line (several lines) that say, "Add new texture . . ." AddNewTexture_Option.JPG **HOW do you do this? **Are there other materials available that we can import into our...
- Sun Jul 04, 2021 7:22 pm
- Forum: Cut2D - General
- Topic: The New Map Thread - Show us where you are in the world
- Replies: 1441
- Views: 4392974
Re: The New Map Thread - Show us where you are in the world
Silver Lake, MN, USA