Vectric Customer

FYI make sure you have background graphics option on.

Thanks for the update

FYI I sent the below info to Vectric support.


I have 10.506 of Aspire on my computer.

It does not say there is a new version available in the upper right hand corner.

The release notes say 10.507 is available.

When I do a check for update it says I have the latest.

The Portal only has 10.505

Thank You. Works in Chrome.

It is the circle in the upper right hand corner with 3 dots. Hover over it and it will say Custom and Control Google Chrome.

Of course it does NOT work nor does Ctrl P. You can not do a ctrl P and print the whole manual!

Unsuccessful on several tries also. 3 possible issues and I think #3 is the most likely. 1) I assumed operator error. 2) changes to windows 10. 3) Vectric has done something to make it harder to print a paper copy. In the past when running into difficulties printing you get 2 responses. You don’t ne...

Unsuccessful on several tries also. 3 possible issues and I think #3 is the most likely. 1) I assumed operator error. 2) changes to windows 10. 3) Vectric has done something to make it harder to print a paper copy. In the past when running into difficulties printing you get 2 responses. You don’t ne...

did you select material boundary and not model boundary?

The last week they said "imminent" apparently they aren't using the Oxford English Dictionary definition.


Something that is imminent is just about to happen: if you light a firecracker and then stick it down your pants, a very bad situation is imminent.

try merging instead of adding

The .5 version is always free, you will have to pay to upgrade to 10, but 10.5 will not cost anymore.

I'm signed up

OK figured it out

If the radius of the curve is close to half or greater "It" can't fit them into the rectangle. So it just jumps back to square corners. An error message stating that would have been helpful.

Just created a second new file and it worked.

went back to first file where it didn't work and it still doesn't work on that file.

created a new 3rd file and it works.

So what default/limit could prevent it from rounding corners on a rectangle on the original file?

Just tried to use fillet tool on the square corners it didn't work either.