Search found 8 matches

by Barrie123
Sat Mar 20, 2021 1:15 am
Forum: Aspire - Gallery
Topic: Curved Sides flat Bottom large dish
Replies: 1
Views: 794

Curved Sides flat Bottom large dish

Curved Sides flat Bottom large dish.JPG
Just completed in French Oak and Osmo Oil for the finish
by Barrie123
Sat Mar 20, 2021 1:12 am
Forum: Aspire - Tips and Tricks
Topic: Curved Sides flat Bottom large dish
Replies: 7
Views: 1745

Re: Curved Sides flat Bottom large dish

Well, with a lot of help and great info from the Vectric users I have finally completed the Curved Sides flat Bottom large dish It finished 1030mm long, 230mm wide, 75mm high Made from a single piece of French Oak an I used Osmo Oil for the Finish. It was cut out with one router bit 120mm long, 12mm...
by Barrie123
Sun Jan 03, 2021 2:33 am
Forum: Aspire - Tips and Tricks
Topic: Curved Sides flat Bottom large dish
Replies: 7
Views: 1745

Re: Curved Sides flat Bottom large dish

I do modelling outside of VCarve (in my case) so I can’t really help there. If you do model this in 3D you could get by with 3 toolpaths: pocket toolpath using the inner oval to get the 60mm deep flat area 3D roughing toolpath between the two ovals 3D finishing toolpath between the two ovals (if I ...
by Barrie123
Sat Jan 02, 2021 8:28 am
Forum: Aspire - Tips and Tricks
Topic: Curved Sides flat Bottom large dish
Replies: 7
Views: 1745

Curved Sides flat Bottom large dish

Good afternoon Is anyone able to assist with the program for cutting out a 1000 mm Long x 200 mm wide x 75 mm oval dish' The requirement is to have a flat inside bottom 15mm thick Curved sides down 60 mm, to the flat inside base. See drawing attached Cut out Board 02 01 2021.pdf This the first one o...
by Barrie123
Mon Oct 19, 2020 12:26 am
Forum: Post Processors
Topic: UCCNC Post Processor for Wrapping
Replies: 5
Views: 2274

Re: UCCNC Post Processor for Wrapping

Thank You,
I appreciate your help.
Barrie123
by Barrie123
Fri Oct 16, 2020 1:08 am
Forum: Aspire - General
Topic: Post Processor
Replies: 13
Views: 1598

Post Processor

Is any one able to advise the post processor for the Rotary Toolpath for a Blue Elephant Chinese CNC.
My Model is a 1600x1300x400 ( 1600x 1300 Table and 400 Gantry )
I use a Rich Auto B18 Hand Controller.
Regards
Barrie
by Barrie123
Fri Jan 03, 2020 9:40 am
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 1018
Views: 2691429

Re: The New Map Thread - Show us where you are in the world

Bunbury
Western Australia
Regards
Barrie123.
by Barrie123
Fri Dec 13, 2019 12:07 pm
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 1018
Views: 2691429

Re: The New Map Thread - Show us where you are in the world

Dalyellup Western Australia
Regards
Barrie123