Search found 10 matches

by Bumps
Wed Oct 09, 2019 8:59 pm
Forum: VCarve - General
Topic: Help!!
Replies: 12
Views: 1036

Re: Help!!

Thanks very much, I will try that. Really appreciate your time and advice.

Bumps
by Bumps
Wed Oct 09, 2019 7:47 pm
Forum: VCarve - General
Topic: Help!!
Replies: 12
Views: 1036

Re: Help!!

Here is the link to the file

https://www.dropbox.com/s/gb9i4f9o2b4sl ... e.crv?dl=0

Hope it works

Bumps
by Bumps
Wed Oct 09, 2019 6:03 pm
Forum: VCarve - General
Topic: Help!!
Replies: 12
Views: 1036

Re: Help!!

Here is the CRV file hope it helps upps too big
Bumps
by Bumps
Wed Oct 09, 2019 3:36 pm
Forum: VCarve - General
Topic: Help!!
Replies: 12
Views: 1036

Re: Help!!

Thanks for the response, but now I am stumped! I have only done the design on V Carve I have not yet cut it as it did not look right, so I do not know how I can send a file, unless there is a way in V Carve to do it that I don't know about :? Just trying to save wood before I make a mess of it! Rega...
by Bumps
Wed Oct 09, 2019 3:01 pm
Forum: VCarve - General
Topic: Help!!
Replies: 12
Views: 1036

Help!!

I can't get the letters clean on a sign I am doing. Can someone please take a look at the photo and tell me what I am doing wrong and how to sort it please

Many thanks

Bumps
by Bumps
Fri Jul 26, 2019 9:30 pm
Forum: VCarve - General
Topic: Help!!
Replies: 4
Views: 765

Re: Help!!

Hi Adrian You were right. I do most of my work on my computer in the house then download to a stick and take it to the computer in my workshop. I recently load VCarve Pro onto my computer in my workshop. I checked my main computer and the post-processor was correct. but when I checked my workshop on...
by Bumps
Fri Jul 26, 2019 4:11 pm
Forum: VCarve - General
Topic: Help!!
Replies: 4
Views: 765

Re: Help!!

No, it is just the same as always, I have gone through everything got me completely baffled.
by Bumps
Fri Jul 26, 2019 11:26 am
Forum: VCarve - General
Topic: Help!!
Replies: 4
Views: 765

Help!!

HELP!! I have a problem that I can't work out. I run with VCarve Pro and Shapeoko XL. When I load a new program the cutter moves to the XYZ position but then does nothing although the computer shows that it is moving through the program! If I load an old file it cuts it no problem! I think it might ...
by Bumps
Wed Jun 19, 2019 3:50 am
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 878
Views: 2497564

Re: The New Map Thread - Show us where you are in the world

I can't get the map to zoom out from the States. Is there a problem? :(
by Bumps
Mon May 06, 2019 2:12 pm
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 878
Views: 2497564

Re: The New Map Thread - Show us where you are in the world

Bill Bertham
Carlisle UK