Search found 20 matches
- Tue Oct 15, 2019 11:05 am
- Forum: VCarve - General
- Topic: Two pieces of plywood for one circle
- Replies: 2
- Views: 518
I want to cut one circle that takes two pieces of plywood. My machine is not big enough to cut both pieces in one cut. So I'm going to start in the bottom left of piece #1 of plywood. When that one is done, how do I set up piece #2? Is there a setting in VCarve Pro to do this?
After getting involved in doing a 3d relief carving its takes to long to do. I cant spend that much time on one picture. I don't want to do a relief carving what else is there.
Just steer me in the right direction to do the 3d relief carving. I tried to message Michael Mizalick but it says I'm not able to send messages at this time. I was going to watch the video on George Washington. Thanks again for the help.
My nephew just passed away last week so I'm trying to do a 3d relief carving for his mother so it's very important to me to do this. I appreciate all the help from you guys.
Where is the PDF located?dwilli9013 wrote:+1 on M Tylers information. Michael Mezalick also offers a very informative pdf on modeling a Santa in Aspire. It is very thorough and explains the underlying techniques when modeling.
Sounds like your are importing a photo and making a model component from it. If so, the issue of darker areas (shadows in the photo) carving too deep is common. To be successful making a 3D relief model from a photo of a person’s face, you need to create underlying shapes to raise areas where neede...
Yes I think they call it a relief carvingAdrian wrote:What type of toolpath is it you're doing?
I'm guessing it's a v-carve in which case you can invert which way a section cuts by adding a vector around or removing a surrounding vector.
Good Morning. I'm trying to do a carving of a boys face. Some parts of the face are going negitive and i need them to go positive. To prevent holes and sunking spots. How can i specify a certain spot to work on. How can i do this or can it even be done. Thanks I'm using Ink Scape and Aspire 9.5
- Mon Aug 20, 2018 8:12 pm
- Forum: Cut2D - General
- Topic: The New Map Thread - Show us where you are in the world
- Replies: 854
- Views: 2471482
Include me also Jpmreno 19275 sisters R, Ponchatoula la 70454