Vectric Customer

Yippe. Thanks again.
Graham

You guys are awesome. Thank you so much for the time and effort on my behalf.
Graham

This is what I have so far. Trying to get the block that is the headstock to taper down to meet the 1 inch neck.
Graham

A little more info. The model is the headstock of a guitar neck. I was able to model the neck and body end of the neck just fine, all merged together well.
Graham

I am trying to cut that shape and keep everything square. The best I could do so far did not leave the top and the bottom in the same plane. The top had an angeled cut across the top from left to right. Thank you for the reply.
Graham

Good morning,
I have not been here in a long time. Been trying to figure out a way to draw this componet with Aspire. Have tried everything i can think of with no success. Is there a way to draw this componet with Aspire. Any help appreciated.
Thank you,
Graham

My bad. Just read the other posts. Sorry guys.
Thanks, Graham

What is the proper bit speed to cut a 3D lithoplane in acrylic. Bit is a tapered .0312 ball nose.
Thanks, Graham

Thank you!
Graham

Are you possibly willing to share the pistol file as well?
Thanks, Graham

BINGO guys. I did it. Cannot thank you guys enough. Tough for an OLD! analog guy to get the hang of this stuff.
Graham

Thanks Randall

Thanks everyone. I said blueprint but it is actually a printed full size plan of a 33 Martin OM 28. I will try to get the file into BMP and c what I can do.
Graham

I had a scan done of a guitar blueprint and I am trying to import it into Aspire. It is a 18.5MB file PDF. I have tried every import feature in Modeling and Drawing. Tried converting it to a PNG file, still no luck. Can someone help me with this?
Thanks, Graham

Thanks Rc. Will view that this afternoon.
Graham