Search found 8 matches

by connfountain
Wed Jun 03, 2020 7:15 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

I will check the video. I am getting 5 fingers even though it is set to 9. I changed it to 7 and now I get four fingers.
by connfountain
Mon Jun 01, 2020 8:02 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

I'm a relative newbie to CNC. I built a cnc a couple of years ago from plywood using kit from Dave Gatton. Then I took a couple of years off while i was building a new house. Not sure I will every be as serious as you are. I have seven grandkids that are my main hobby :) But i am going to build a ne...
by connfountain
Sun May 31, 2020 11:43 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

Thanks!. I am going to just modify the back panel and bottom manually using 1.7. it seems to do a good job of laying out the fingers. T I see you mention you have a DIY 60 x 120 CNC. Did you post that build information any where on the Net ?? I would love to build a new one about that size. Avid/ CN...
by connfountain
Sat May 30, 2020 3:18 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

Thanks for the quick reply Jim. There is still some error either in my understanding or in the calculation of the back length and bottom dimensions. I am guessing in the calculation it is using the default 0.5 material width instead of the 0.477 actualy. Or perhaps I dont understand the dado height ...
by connfountain
Sat May 30, 2020 3:34 am
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

Thanks Jim. My CRV is attached and i am using all the same setting as before. The fingers on the front are in the correct position. Thanks for correcting that. But there is still a problem with calculation in the width of the back and width (maybe length ) of the bottom. The back and width (left to ...
by connfountain
Thu May 28, 2020 10:27 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

I found a couple of issue. the Fit is a little tight but It might be on my end. First time running this machine after recent move and it need a little tweaker. however, I found out the placement of the fingers on the front piece does not match the sides. PDF attachment showing my settings and the re...
by connfountain
Sun May 24, 2020 4:58 pm
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

thanks for the quick reply. It was my fault for not setting the directory, but it would be good to have a more friendly message.
Just set it up to cut a drawer for my outdoor kitchen. Awesome software.
by connfountain
Sun May 24, 2020 3:59 am
Forum: Gadgets - User Submissions
Topic: Drawer Maker
Replies: 23
Views: 3254

Re: Drawer Maker

Drawer maker 1.2 is included in easytools20200522. And i get this error about attempt to index local file.


VCarve Pro
Script:
Line: 915
(global CutListfileWriterHeader)
x
attempt to index local 'file' (a nil value)
OK