Search found 4 matches

by tigermoses
Thu Feb 21, 2019 12:55 pm
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 1424
Views: 4361883

Re: The New Map Thread - Show us where you are in the world

Tiger Moses
Montgomery, TX 77316
by tigermoses
Sat Mar 11, 2017 3:46 pm
Forum: VCarve - General
Topic: adding a specific bit
Replies: 5
Views: 3877

Re: adding a specific bit

I'm American, so I'm going with the Scottish lad
by tigermoses
Sat Mar 11, 2017 6:16 am
Forum: VCarve - General
Topic: adding a specific bit
Replies: 5
Views: 3877

adding a specific bit

Not having luck adding as form tool, but I'd like to add this bit to my tools, how should I define it

https://www.amazon.com/gp/product/B00VFYA0ZU/

thanks
by tigermoses
Thu Mar 02, 2017 7:08 pm
Forum: VCarve - General
Topic: Need help choosing the correct end mill
Replies: 6
Views: 3360

Re: Need help choosing the correct end mill

So you wanted to know Rough vs Smooth cuts - here is a set of images below look to right to see original board surface rough cut will remove as much material as possible, without getting into the smooth cut "zone" smooth can then just smooth, not work on removing everything. Rough cutting can save a...