Vectric Customer

Ok, thanks. I wanted to make sure there wasn't a way to do that...

I have a tool for cutting a finger grip in a door. Can I upload this to VCarve? I have a screenshot attached with the shape of the tool.

Wenger
Arthur, Illinois USA
(Talent 510)

Thanks!

Luke

Can anyone tell me where to acquire this font in the attached picture, the word "Welcome"?

Luke

Ok, thank you for your help!

Luke

How do I get the fonts that I download from the web into VCarve Pro?

Thanks,
Luke

Yes great job, Steven! Thanks! The only reason I had the 12'' offset was that I get slightly better vacuum away from the edge of the router bed...

Thanks for that onion skin idea. I think that might be a good option if I keep it really thin!

Yes we have good vacuum for holding down parts, however, I think they will still want to move on me considering that the individual part size is about 3.5''x4.5''. I agree that tabs will be very time consuming to clean up with this many parts...

Well I appreciate your help. Perhaps Vectric might consider a better option to adjust tabs on a large project like this.... A 48x96 sheet of these small parts looks a bit daunting.

LittleGreyMan wrote:

Luke@WWC wrote:How do I add duplicate tabs?

Follow the link I provided. Tom also answered this question.

So is there no other way to edit the tabs that by doing each one manually? Thats fine if there are only 10 parts in the sheet, but when there is over 400 that's not so fine...

That was actually just a trial sheet. It will be a 48''x96'' sheet with a little over 400 parts that I'm cutting out so that complicates matters abit. How do I add duplicate tabs?

Here it is.

Yes I selected them all then added tabs.