Search found 7 matches

by HMPrintDesign
Tue Jul 07, 2020 7:00 pm
Forum: Laser Module - Gallery
Topic: Laser Module
Replies: 1
Views: 68

Re: Laser Module

Hello,

Any plans for Boss lasers.

-Wayne
by HMPrintDesign
Mon Mar 30, 2020 3:32 pm
Forum: Cut2D - General
Topic: The New Map Thread - Show us where you are in the world
Replies: 805
Views: 2420547

Re: The New Map Thread - Show us where you are in the world

22 Monticello Street
Richfield Springs, NY 13439
by HMPrintDesign
Thu Aug 15, 2019 3:10 pm
Forum: VCarve - Tips and Tricks
Topic: Custom Form Tool
Replies: 2
Views: 653

Custom Form Tool

Hello all,

I have been trying to create a custom form tool for a special bit we had ordered. No matter what I try I get no suitable vector selected for form tool. I created a right handed edge profile and it won't except any shape I want to use.

Any advice would be welcomed.

-Wayne
by HMPrintDesign
Sun Feb 10, 2019 6:03 pm
Forum: VCarve - General
Topic: On the Fly Font Install Like CorelDraw
Replies: 1
Views: 531

On the Fly Font Install Like CorelDraw

Hello, I hope a moderator can follow this. I have over 3000 fonts and obviously cannot load all these at startup. Corel allows on the fly use of fonts whether they are installed or not. It would be so beneficial if V-Carve Pro could also utilize this ability. I would appreciate if this could be impl...
by HMPrintDesign
Tue Oct 09, 2018 7:01 pm
Forum: VCarve - General
Topic: Putting a flower into a dish
Replies: 1
Views: 678

Putting a flower into a dish

I for the life of me just can't get this... what I want is a dish .5 inches deep into .75 material. The inside that a sunflower (3d) . I have tried for about 2 hours now.. either the dish is set into the board too far leaving an edge or the flower is above the z of the top of the material. If someon...
by HMPrintDesign
Fri Aug 25, 2017 3:03 pm
Forum: VCarve - Tips and Tricks
Topic: Not to carve a box over a 3d image
Replies: 1
Views: 1624

Not to carve a box over a 3d image

Hello, I am tasked with making a fantasy football plaque. I have the design just about ready, the only hang up I'm getting is that I want a rectangle that is placed over the 3d football to NOT be carved but left blank so that I vcarve text into it. For the life of me I just can't figure out how to d...
by HMPrintDesign
Mon Jul 11, 2016 5:28 pm
Forum: VCarve - Tips and Tricks
Topic: 3D Text in a Dish
Replies: 2
Views: 2443

3D Text in a Dish

Hello all,

I'm having difficulty creating a dish with text that remains full height of the material. I have it all almost figured out.. except I just can't get the HM Print Design part to remain uncarved and at full surface height.

Any ideas would be greatly appreciated.