Search found 3 matches
- Tue Jun 09, 2015 7:59 pm
- Forum: VCarve - Tips and Tricks
- Topic: Avoiding Machine Gotchya's
- Replies: 48
- Views: 199990
Re: Avoiding Machine Gotchya's
This is very true as well. Unless you have your acceleration set at extreme amounts which in turn will cause in a higher inaccuracy tolerance. Also at high speeds you have to remember to set your acceleration angle. You can lose square corners past 110 IPM if you are set to >22.5. I know from past e...
- Tue Jun 09, 2015 3:36 pm
- Forum: VCarve - Tips and Tricks
- Topic: Avoiding Machine Gotchya's
- Replies: 48
- Views: 199990
Re: Avoiding Machine Gotchya's
I run my machine to my Onsrud designated chip load period. I am not sure what you all consider speed but I use my Onsrud 56-600 bit for acrylic and with the chip load my feed rate comes out to around 210 IPM (53 MPM) I believe. I never have problem and I have flawless cuts that almost look polished....
- Thu Apr 02, 2015 2:37 pm
- Forum: Aspire - Tips and Tricks
- Topic: Clean up pass
- Replies: 4
- Views: 5754
Clean up pass
Hello all, I am new to Vcarve Pro and not completely sure how to do something. The company I started working for has Vcarve Pro Version 5 and I am cutting out a lot of profiles. I so far like the simplicity and easy use of Vcarve, however, something I am having troubles doing is setting up a clean u...