Vectric Customer

The spindle will likely be an off-the shelf 2 1/4 HP router. So, all the controller has to do is move it around. Adding the Z-axis would require a controller replacement for sure, but for now I would be happy just to use Cut 2D for some simple through-cutting and pocketing at mechanically preset dep...

I would love to run WinCNC. Can I set it up to run the servo drives existing on the machine? Or would it be easier to swap everything out for a stepper system? The machine has no z-axis, only a pneumatic actuator limited by mechanical stops. It has a drilling block with 3x3 drills on 32mm centers, a...

Hey, good to hear from you, Gary! Hope you're well. This is code that was included on the 3.5" floppy :roll: disk with the machine. Yes, apparently you can still buy a floppy drive on the internet. I have successfully run a "Demo" program, but it drilled quite a few more holes than the code would in...

I have an old Masterwood Speedy 207 CNC boring machine that I will be modifying with the addition of a spindle, for use as a hobby point to point machine.

I would love to use VCarve again, what are the chances of finding a Post Processor to make this machine work?