Search found 3 matches
- Sun Jun 30, 2019 11:42 pm
- Forum: VCarve - General
- Topic: Setting max depth on roughing pass
- Replies: 10
- Views: 3964
Re: Setting max depth on roughing pass
Thanks for your replies. I have used a rectangle to limit the X/Y of the second finishing pass and a zero plane to limit the depth. The way I prevent cutting too much air is to find the part of the gcode that is at a useable depth (say, 7mm down) and start the programme from there. LinuxCNC makes th...
- Sun Jun 30, 2019 12:05 pm
- Forum: VCarve - General
- Topic: Setting max depth on roughing pass
- Replies: 10
- Views: 3964
Setting max depth on roughing pass
Hi there, I'm carving a 3D model and am using an 8mm endmill for the main roughing pass. The issue is that there is some 28mm deep detail that the 8mm endmill won't fit into, so the roughing pass doesn't touch any of this at all. I would like to run a 2nd roughing pass with a 3mm endmill. This can o...
- Sat Apr 20, 2019 12:27 pm
- Forum: Cut2D - General
- Topic: The New Map Thread - Show us where you are in the world
- Replies: 1439
- Views: 4382404
Re: The New Map Thread - Show us where you are in the world
Allistar, Tauranga, New Zealand.