Search found 6 matches
- Fri Oct 25, 2019 10:47 pm
- Forum: Aspire - General
- Topic: Aspire upgrade
- Replies: 3
- Views: 1719
Re: Aspire upgrade
Thank you. I will pass on the information.
- Thu Oct 24, 2019 5:35 am
- Forum: Aspire - General
- Topic: Aspire upgrade
- Replies: 3
- Views: 1719
Aspire upgrade
Asking for a friend
He has Aspire 4.514. If he upgrades what does he upgrade to? 8, 9, or 10?
he sold his CNC some time ago but still does some drawing and has me cut them for him.
Any information will be helpful.
Thanks
Wooddogg
He has Aspire 4.514. If he upgrades what does he upgrade to? 8, 9, or 10?
he sold his CNC some time ago but still does some drawing and has me cut them for him.
Any information will be helpful.
Thanks
Wooddogg
- Thu Aug 29, 2019 5:08 pm
- Forum: VCarve - General
- Topic: Carving
- Replies: 11
- Views: 4302
Re: Carving
Mike s
wooddogg@att.net
wooddogg@att.net
- Sat Aug 17, 2019 6:43 pm
- Forum: VCarve - General
- Topic: Carving
- Replies: 11
- Views: 4302
Re: Carving
]Thanks to all for your replies.
I think it is an Air Force Logo. They are having a reunion next month and he would like to hang it then.
Sharkcutup I wish I had your talent, it is amazing what you did in just a few hours.
As you can see this is what I cane up with.
Am I on the right track?
I think it is an Air Force Logo. They are having a reunion next month and he would like to hang it then.
Sharkcutup I wish I had your talent, it is amazing what you did in just a few hours.
As you can see this is what I cane up with.
Am I on the right track?
- Fri Aug 16, 2019 5:13 pm
- Forum: VCarve - General
- Topic: Carving
- Replies: 11
- Views: 4302
Carving
I was asked by a friend if I could carve this picture of a wing. I have looked at it for a week now and still don't know where to start. Any suggestions?
- Sun Mar 16, 2014 5:01 pm
- Forum: Aspire - Tips and Tricks
- Topic: How do I add add a postp to the trial version of photovcar
- Replies: 1
- Views: 2181
How do I add add a postp to the trial version of photovcar
I have tried following the instructions that were sent to me but keep getting an error message . Any suggestions ?