Vectric Customer

Ok, I though I would try.

Hello, I have used Aspire to edit a photo, and copied cut and paste parts of the image. I did this to change the image from a rectangle to a circle to fit the circular material. Now I have multiple BMP "parts" that I am unable to export. When I do export the only part that is exported is the circle ...

Thank you for everyone's help. This is the end result. Sometimes when I am so close to a project, I can't see the bigger picture. ..

still not right.... but thank you

I am going to run it now... and I will let you know.

the machining allowance is 0.05. I will reduce it and see what happens.

I have a 3 inch (42 wide x 15 high) slab that I am carving a 3d scene into. My roughing pass tool 0.25 EM. does not go into the letters E, S and A etc... therefore on my finish pass 0.25 Ball nose, attempts to cut carving down the entire 1.8 inch depth. This of course is hard on the tool and my nerv...

Update, I called Laguna and they tell me when I updated the Aspire software my post processor is not correct in the update. They are sending me the correct processor to install.

https://www.dropbox.com/s/nmvs1a5te4028 ... crv3d?dl=0

I have not tried changing the direction. I will do that today.
I am sorry I didn't send the correct file.
I do appreciate your help.

To set the z zero, I have a block that is the exact height of the z zero for my machine. ( I have the z zero set for the middle of the cylinder, not the surface). I zero the z height to the top of the block. The start of the model it cuts exactly as it should with the tail of the fish. When it gets ...

rotary is parallel to the x
Luguna turner mm.(NC)
I use the same post processor for the rounding and roughing tool path

2nd picture.

this is the wrapped preview

This is the preview