Vectric Customer

Have you tried a search on the forum? Don't know if what you are looking for has previously been posted but do know that some guitar files have been uploaded to the forum in the past

Have you tried saving each toolpath separately to see if that works? Do the toolpaths use the same bit?

I don't know anything about your machine or the control software you are using so no idea how it works with toolpaths

Just to add to what Adrian has said not only will you get the save icon back but also the undo & redo icons

Only by adding the sheet number to the layer at the moment, send a feature request to Vectric, I have already done that because I would like to see better management for layers & sheets, hopefully at some point something will be done if enough people ask & it is something that they can do :lol: :lol...

I work in a similar way to Adrian, the CNC machines have their own control computers & these have just the Control software on them they are not connected in any way to the internet. Toolpath files I transfer via a USB stick. I have a design computer at the workshop so if changes are needed then its...

you could try emailing support & asking them for permission to use it if you haven't done so already.

support@vectric.com

Try a search on the forum, I know a few different grips have been posted in the past but couldn't tell you which ones or if they are still available for download

Not sure I fully understand but I think you are using the wrong tools, the invert function & apply are available in the picture editing tool & I don't think that is what you are trying to do. I think you are trying to create a component that is carved into the material rather than a component that i...

Are you using this new computer to run the control software for your machine as well or is the new computer just for your design work.
If you are using the same computer to control your CNC & have installed the CNC control software on it are you sure you have set it up the correct way?

If you use the selected vectors option for your machining limit boundary then you can avoid machining the middle. if you don't already have one then draw a vector around the perimeter of the model, select that vector & the circle vector & use them as your boundary

Thanks for updating the post & good to hear that you are happy with the results you are now getting, just one small point. With a CNC router it is very unlikely you will ever get a good chip load with a 4 flute endmill, they are really designed for CNC mills & metals where a different type of spindl...

hobbyist wrote: ↑

Fri Jan 26, 2024 6:01 pm

Another plus for the chamfer toolpath, it does multiple passes.

So does the profile toolpath

If you are doing a profile cut in one pass then make sure your machine is up to it, that is a lot of material to remove in one pass especially at the top where the V is at it's widest :lol: :lol: Not all machines are going to handle that well. Not just the depth in one pass but the hold down as well...

There are a lot of machine manufacturers & models that aren't listed but as you have found out it is easy enough to set up yourself as long as you know which controller or control software you are using so you can select the correct post processors. If you are using the trial version you can go ahea...

What sort of touch plate do you have & what is the tolerance on it? Is it in a fixed position or is it the sort you put on the material surface or machine bed each time you use it? Is it a single touch or a 2 touch probe & have you taken the time to set it up properly? If you approach speeds are to ...