Setting Defaults

This forum is for general discussion regarding VCarve Pro
Post Reply
tbrazz
Posts: 2
Joined: Mon Dec 26, 2005 8:45 am
Location: Australia

Setting Defaults

Post by tbrazz »

Hi
I was wondering if it was possible to set the defaults so as the program opens in full screen mode, centres vectors to page, also uses mm units
Thanks Tony

User avatar
Paco
Vectric Wizard
Posts: 480
Joined: Fri Sep 16, 2005 6:30 pm
Location: Valcourt, Québec, Canada
Contact:

Post by Paco »

For full screen display at startup, see attached. I'll let the other point to PROS...

hbhbbb

Post by hbhbbb »

Thanks for tht Paco, got that sorted
Tony

Post Reply