cnc simulator
-
- Posts: 11
- Joined: Mon Mar 05, 2012 10:51 am
- Model of CNC Machine: Piranha PJCM 1325-3
cnc simulator
Can anyone suggest a good cnc simulator software package
- IslaWW
- Vectric Wizard
- Posts: 1402
- Joined: Wed Nov 21, 2007 11:42 pm
- Model of CNC Machine: CNC Controller Upgrades
- Location: Bergland, MI, USA
Re: cnc simulator
For ShopBot and Mach all you should need is the software, comm cables and a controller card. Card wont care if there is no CNC attached. Maybe add a BO board to supply power and add a few LED's. This would get you actual "at the machine" simulation.
If you are looking to simulate your designs into finished products, nothing will beat Vectric softwares previews. Download a free trial and give it a go.
If you are looking to simulate your designs into finished products, nothing will beat Vectric softwares previews. Download a free trial and give it a go.
Gary Campbell
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com
GCnC Control
ATC & Servo Controller Controller Upgrades
GCnC411 (at) gmail.com