A little video of my attempt at turning a fractal into something that looks like a chip carving. Lots and lots of hours in vcarve resizing and moving groups of vectors around. Machined in mahogany which seems to hold up to those pockets right next to each other across the grain pretty well.
Here's a clip from my workshop: http://youtu.be/Rv6t7P-Sqmg I'm routing the outlines and soundhole of a concert guitar soundboard. The workpiece is held with vacuum and the white vacuum board is made out of high pressure laminate (similar to Formica, only 1/2" thick). It works like a dream...
Here is a video of the Radiator shoe base plate, dust collection shoe. I used Radiator brushes for the bristles and hinges to make bit changes easy. If folks are interested I can post the file somewhere else on the forum.
Wooden Gear Clocks Here is a link to my you tube video of a wooden gear clock cut with VCarve Pro https://www.youtube.com/watch?v=h0FJnSiRK4Y You can also check out a few more of my clocks. No cnc footage but if anyone is interested I could upload some to youtube