1013 IntelliCarve Post Processor

This forum is for general discussion regarding VCarve Pro
Post Reply
jstashman
Posts: 2
Joined: Sun Nov 27, 2011 2:29 pm
Model of CNC Machine: 1013 IntelliCarve

1013 IntelliCarve Post Processor

Post by jstashman »

Is there a post processor for the Oliver 1013 IntelliCarve.

tmerrill
Vectric Wizard
Posts: 4797
Joined: Thu May 18, 2006 3:24 pm
Model of CNC Machine: ShopBot
Location: North Carolina

Re: 1013 IntelliCarve Post Processor

Post by tmerrill »

They don't have a very good website, but if you follow their specsheet instructions you will need to contact them.

Good Luck.

Tim
Attachments
Oliver machine.JPG

jstashman
Posts: 2
Joined: Sun Nov 27, 2011 2:29 pm
Model of CNC Machine: 1013 IntelliCarve

Re: 1013 IntelliCarve Post Processor

Post by jstashman »

Tim,

Thanks, I sent them an e-mail.

User avatar
rhds1
Posts: 4
Joined: Wed Aug 22, 2012 7:48 pm
Model of CNC Machine: Oliver 1013 Intellicarve
Location: Southern Missouri, USA

Re: 1013 IntelliCarve Post Processor

Post by rhds1 »

This is old news likely, but I talked to the Tech Support Rep today. He said he did
have a post processor and would send it to me via email. However he was at a
manufacturing show in Atlanta until next week. He gave me his email address
in order to send my request so when he got back it would tickle his memory.

Like I said likely this is all settled, but I just ran across this thread so added my
two cents. Rick

Post Reply