Finished cutting a bunch of grapes on a plaque today, using Cut3D.
The finished part is about 12" x 10", and cut in 3/4" MFD, using a
1/8" ball nose bit. Much of the design was created in ModelMill.
Paul N
Grape Plaque.
Very Good!
I like it! I've never heard of modelmill. Did you model this from the ground up? Very good if you did! You definitely have a talent.
Keep up the good work.
Gotta look up ModelMill!
I like it! I've never heard of modelmill. Did you model this from the ground up? Very good if you did! You definitely have a talent.
Keep up the good work.
Gotta look up ModelMill!
Dave
Epilog 24TT 40w and Legend 36EXT 75w Laser Engravers, Roland SP-300V, BabyLoc PR600 Embroidery Machine, Panther 24" Vinyl Cutter, Mighty Presses (hat & T-Shirt), PRT48 Router
Epilog 24TT 40w and Legend 36EXT 75w Laser Engravers, Roland SP-300V, BabyLoc PR600 Embroidery Machine, Panther 24" Vinyl Cutter, Mighty Presses (hat & T-Shirt), PRT48 Router
- Paul_n
- Vectric Wizard
- Posts: 316
- Joined: Mon Aug 22, 2005 1:12 am
- Model of CNC Machine: ShopBot PR96
- Location: Cartersville, Georgia
Hey Dave....
Thanks for the kind works....
The story on ModelMill, is that it 'was' written 6 or 7 years ago, and was never
finished. The two brothers, set it aside, and wrote what is sold as Enroute-Pro
today.
Some of the parts in the grapes were developed elsewhere, and I just added
parts together....
One of the problems with ModelMill, is that it will only export a 3D, .dxf file, and
some of these files become 'huge'. I think this one was over 100MB.
Paul N
Thanks for the kind works....
The story on ModelMill, is that it 'was' written 6 or 7 years ago, and was never
finished. The two brothers, set it aside, and wrote what is sold as Enroute-Pro
today.
Some of the parts in the grapes were developed elsewhere, and I just added
parts together....
One of the problems with ModelMill, is that it will only export a 3D, .dxf file, and
some of these files become 'huge'. I think this one was over 100MB.
Paul N