HELP!!
I have a problem that I can't work out.
I run with VCarve Pro and Shapeoko XL. When I load a new program the cutter moves to the XYZ position but then does nothing although the computer shows that it is moving through the program!
If I load an old file it cuts it no problem! I think it might be a programming problem although really I have not got a clue. Is anyone able to help?
Help!!
- Adrian
- Vectric Archimage
- Posts: 14650
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Help!!
Have you selected a different post processor (when you save the toolpaths from VCarve) by mistake or changed it?
Re: Help!!
No, it is just the same as always, I have gone through everything got me completely baffled.
- Adrian
- Vectric Archimage
- Posts: 14650
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Help!!
Does your machine transfer the code via an SD card? Might be worth trying a different one if so. There have been people with similar issues in the past here that did that and it worked again.
Re: Help!!
Hi Adrian
You were right.
I do most of my work on my computer in the house then download to a stick and take it to the computer in my workshop. I recently load VCarve Pro onto my computer in my workshop. I checked my main computer and the post-processor was correct. but when I checked my workshop one it was wrong! I have changed it and now everything is back to normal.
Thanks for bringing my attention to it.
You were right.
I do most of my work on my computer in the house then download to a stick and take it to the computer in my workshop. I recently load VCarve Pro onto my computer in my workshop. I checked my main computer and the post-processor was correct. but when I checked my workshop one it was wrong! I have changed it and now everything is back to normal.
Thanks for bringing my attention to it.