rtfosmoe wrote:Very nice! Any chance you can upload and share the file for the pen box?
Sure. This is the one made from Canarywood. Here's the linkhttps://1drv.ms/f/s!Al5SVN2NwjTqxgjuy97vNSMWxpN_
I made the pen and pencil a little non-standard by drilling the hole for the brass tube and turning the blank round on my lathe. The tubes were not glued in until after coming off of the CNC. I measured the tubes and designed the blanks accordingly. The top and bottom of the box was designed as a two-sided project using the asymmetrical 3 hole method in Aspire and carved as raster.