CNC made bench and chair

This is the place to post images of work produced using Aspire

CNC made bench and chair

Postby Gocarter » Mon May 20, 2019 4:51 pm


I have made some prototypes of a bench and chair. I made them in spruce (the black is spruce with General Finishes dye stain). I just wanted to see how the design looked, and how it felt. Designs can look great on paper (or onscreen) but don't deliver on comfort.

I used a corner chisel to square up the corners of the finger joint. I cut the left side first, and found it was a bit too tight, so I widened the joint by 0.001 on each side, and it fit perfectly.

I will modify the chair seat contour. The ridge in the middle is fine if you are sitting up perfectly straight, but becomes a bit...intrusive if you slide forward at all in your seat. The ridge in the bench is much more comfortable.
I cut all the parts on my CNC, and used my Aurio rasps (fantastic tools!) to do some profiling.
Vectric Apprentice
Posts: 21
Joined: Sat Sep 17, 2016 1:56 am
Location: Calgary Alberta
Model of CNC Machine: PDJ pilot pro

Re: CNC made bench and chair

Postby Wayne Locke » Tue May 21, 2019 12:26 am

Nice designs. Nice seat. I like the bench seat with the bottom profile.
Wayne Locke
Vectric Apprentice
Posts: 81
Joined: Wed May 09, 2007 9:27 pm
Location: Austin, Texas

Re: CNC made bench and chair

Postby PSutter » Fri May 24, 2019 12:58 am

Nice work. I like the artistic design, very eye catching.
Posts: 27
Joined: Sun Dec 09, 2018 8:57 pm
Model of CNC Machine: E-Z Router

Re: CNC made bench and chair

Postby Creation in Wood » Fri Jun 07, 2019 2:20 am

Wow, what a chair
Thank You
User avatar
Creation in Wood
Vectric Wizard
Posts: 452
Joined: Thu May 28, 2015 8:58 pm
Location: Monument, Colorado USA
Model of CNC Machine: Legacy Maverick CNC 4x8

Return to Aspire - Gallery

Who is online

Users browsing this forum: No registered users and 12 guests