Toolpathing Hair vectors that continue off the Head

This section is for useful tips and tricks for Aspire

Toolpathing Hair vectors that continue off the Head

Postby JoniEl » Sat Apr 06, 2019 7:14 pm

This image shows my Lincoln model that I'm trying to toolpath with 1/8" ballnose for beard and clothes, and 15-degree V-bit for Hair and Beard. There's a lot I don't know.
Lincoln Modeled to achieve V-bit 15-deg on Hair and Beard.JPG


1. Since the hair runs off the head, the Heights change and I get this 2nd image from the toolpaths:
Lincoln 3D Finish of Head 1st--.125 Ballnose. Loses Hair height.JPG



2. If I do the head first and make boundary for the Hair, it cuts away where the hair should add on.


3.If I Boundary just the head with the Finish tool. then try to add beard or hair v-bits, I only get the 2D vector used to permit the 3D Toolpath.


I'm wanting to make the first image with the V-bit limit heights correct. Thanks for any straightening me out.
JoniEl
 
Posts: 1
Joined: Mon Mar 11, 2019 9:25 pm
Model of CNC Machine: Stepcraft 840 Black Edition

Re: Toolpathing Hair vectors that continue off the Head

Postby SteveNelson46 » Sat Apr 06, 2019 8:15 pm

If you already have the model of the face and are trying to add the hair, try putting a check mark in the "Project toolpath onto 3d model" checkbox.
Steve
User avatar
SteveNelson46
Vectric Wizard
 
Posts: 554
Joined: Wed Jan 04, 2012 2:43 pm
Location: Tucson, Az.
Model of CNC Machine: Camaster Stinger with Recoil Lathe

Re: Toolpathing Hair vectors that continue off the Head

Postby TReischl » Sun Apr 07, 2019 12:48 am

You need to have a base for the hair to sit on.

When I look closely at the model there is a very apparent top of skull line, that line has to go away. you need to add a component that blends with the skull near the start of the hairline on the forehead and gracefully tapers to where the hair meets the base plane.

Capture.JPG
"If you see a good fight, get in it." Dr. Vernon Jones
User avatar
TReischl
Vectric Wizard
 
Posts: 2907
Joined: Thu Jan 18, 2007 6:04 pm
Location: Leland NC
Model of CNC Machine: 8020 Build 48X36X10 RP 2010 Screenset


Return to Aspire - Tips and Tricks

Who is online

Users browsing this forum: No registered users and 5 guests