by loopacrylics » Fri Mar 29, 2019 1:41 pm
Hello. I'm new to photo Vcarve. I only have the trial version as I am figuring out if its right for me. I'm having errors with my program though. Image size is 7.8" X 7.8" Z zero is from machine table (how i always do it in vcarve) material thickness is 1 inch. Cutting parameters im using a 30 degree engraving bit. It is tool number 8 in my tool changer and i have that set in my program but it keeps putting in tool 1 instead of 8. Also when it puts tool 1 in i get an error saying T1 197.14 (+X) e306. I'm sure you folks dont know what that means but maybe someone can give me some advice as how to better set this program up. I use Vcarve pro and aspire with no problems. The post processor is (AXYZ) .nc