Any assistance in what I should be doing to correct this would be Greatly Appreciated.
Here is the Screen that I see when attempting to create a Tapered Rotary Cut and am attempting to set the Job Up. I'm attempting to design a Cut Profile for a Pool Cue Lower Section and this is before I even Add any Graphics to the Design. Other than Highlighting the Gap Inside the Model, I haven't made any changes. And it doesn't matter what I attempt to do as I can get rid of the Error Message. The original Design called for a Rotary Job of 2" by 29" on the Center of the Job. I've opened the Component Properties and entered 0.8 in the Base Height, Clicket Tilt and Set the angle to 3 Degrees along with clicked on the middle Left and Middle Right in the 2D view port. When it comes to Adjusting the Modelling Plane to a 0 Gap inside the Model. I become Lost in the Whole Process.