Hello,
Could someone steer me in the right direction regarding matching margins? I have made a simple 80mmx 80 mm dish, my material is 120mmx120mm. I am using a 1/4. “ straight bit. I am also using tabs. How do Ikeep the machine from milling all of the extra material outside of the actual piece? If the machine mills all of the surrounding material , then what do the tabs attach to?
Machining margins
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Machining margins
I don't have Cut 3D, but as no one has answered you, I'll take a stab at it. Select the out line vector of your bowl, then generate your toolpaths. If Cut 3D allows a "zero plane" be sure to use it so you get a smooth top edge at the material surface.
- adze_cnc
- Vectric Wizard
- Posts: 4329
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: Machining margins
On tab 3 under "Machining Margins around Model" are you using "Use Model Silhouette"? If not you might want to read up on it.
Re: Machining margins
I am kind new to this all too to preface anything I say but it sounds like you need to make a boundary around the vector your carving. In the modeling tab highlight the vector listed and then above it look for the "Create vector boundary around selected components". Then when you select the machine tool path select "Model boundary" in the machine limit boundary selection.
-
- Vectric Wizard
- Posts: 415
- Joined: Wed Nov 19, 2008 7:28 pm
- Model of CNC Machine: EZ-Router
- Location: Bronkhorstspruit, South Africa
Re: Machining margins
This is not Aspire or V Carve Pro, it is Cut3D.ttocs wrote:In the modeling tab highlight the vector listed and then above it look for the "Create vector boundary around selected components". Then when you select the machine tool path select "Model boundary" in the machine limit boundary selection.
There is no Modelling Tab or Create Boundary options.
As Steven pointed out, the way to add extra material around the model is as follows.
Select “Use Model Silhouette”
Then Under “Machining Margins around Model add the amount of material necessary to add the tabs to.
I hope this helps.
Joz