26 posts • Page 1 of 2 • 1, 2<Previous topic | Next topic>
duster wrote:Ok, I watched the moulding tutorial. However, I couldn't see how this was going help me produce
the beveled edge I'm trying to get on the oval top. I seem to be missing something. I can draw the
oval, and it's offset edge. But how do I get to the beveled edge?
highpockets wrote:Using the Create Line tool draw a vector at a 45° angel 3.182" long. Or with out math, draw a 2.25" x 2.25" rectangle then using the Create Line tool draw a line for corner to corner.
martin54 wrote:highpockets wrote:Using the Create Line tool draw a vector at a 45° angel 3.182" long. Or with out math, draw a 2.25" x 2.25" rectangle then using the Create Line tool draw a line for corner to corner.
Or you could draw a 2.25" square![]()
![]()
![]()
![]()
Return to VCarve - Tips and Tricks
Users browsing this forum: No registered users and 3 guests