wrexler wrote:Newb here...
I recently acquired a AXYZ 4008, with the old style control box, using AXYZ Toolpath to send jobs.
I have tried all the AXYZ post processors listed in the VCarve software, and most of them "Work" my problem is that toolpath seems to strip a lot of the setup done in VCarve out of the file.
The biggest issue is the material size, Toolpath only registers the extents of the job loaded, I then have to enter in the material size and attempt to compute the offsets manually. Am I missing something? this seems very counter intuitive. It also strips the selected tool RPM,
Toolpath seems very powerful given the deceptively simple interface, but I want to do the setup work in VCarve. I have seen posts about using a DNC program to download the nc file directly to the controller, but my setup didn't come with that, and I have read that AXYZ no longer supports that.
Any help is appreciated
Users browsing this forum: No registered users and 1 guest