a simple bowl with a mapped model

This is the place to post images of work produced using Aspire
User avatar
TReischl
Vectric Wizard
Posts: 4579
Joined: Thu Jan 18, 2007 6:04 pm
Model of CNC Machine: 8020 48X36X7 RP 2022 UCCNC Screenset
Location: Leland NC

Re: a simple bowl with a mapped model

Post by TReischl »

Len-Tikular wrote:Thanks all, I had my material setup, set incorrectly. It was 6mm below the surface of the material.

Interestingly enough I do not have zero plane insert in Aspire 4.5

Thanks

George
There is a zero plane insert in Aspire 4.5 in the Model Menu at the top of the screen.

Model/Add Zero Plane

Definitely there, since I run 4.5 every day.
"If you see a good fight, get in it." Dr. Vernon Johns

User avatar
Len-Tikular
Vectric Wizard
Posts: 415
Joined: Sat Feb 13, 2010 11:27 am
Model of CNC Machine: Home made revision 3
Location: Denholm Scotland.

Re: a simple bowl with a mapped model

Post by Len-Tikular »

Jobs all done and dusted Martin, thanks all for the help. Looking good if I must say so!

George
Len-Tikular (A glider pilots dream cloud)

Aspire 10.5
Mach4 Hobby
Ess Smoothstepper + C11g+C10s

User avatar
martin54
Vectric Archimage
Posts: 7339
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
Location: Kirkcaldy, Scotland

Re: a simple bowl with a mapped model

Post by martin54 »

Glad to hear its all finished, of course you know that without pictures it didn't happen George so where are they :lol: :lol: :lol: :lol:

User avatar
Len-Tikular
Vectric Wizard
Posts: 415
Joined: Sat Feb 13, 2010 11:27 am
Model of CNC Machine: Home made revision 3
Location: Denholm Scotland.

Re: a simple bowl with a mapped model

Post by Len-Tikular »

amberfinished.JPG
Good call Martin,
Not a very good picture but here it is,

Regards

George
Len-Tikular (A glider pilots dream cloud)

Aspire 10.5
Mach4 Hobby
Ess Smoothstepper + C11g+C10s

Post Reply