I made a 1.5 'high heart shaped box with a heart shaped pocket off set by .25 from the out side 1.25 inches deep.
Then I used the same heart shape and made a lid. Using the same vector as I did for the pocket and the out side shape I cut a pocket there. Then another toolpath to cut the top out.
Well to my surprize the top did not fit into the pocket in the bottom.
So I am trying to figure out to set up to cut the inner shape smaller in the top to allow it to fit
Is there some way to do a inner cut allowance.
Or how do I make the top fit into the box.
Jeff