adding logo to design & make plaque
adding logo to design & make plaque
Hello, Newbie here and hoping for help. I have purchased a design & make hockey plaque and am trying to add our teams logo to the area of the plaque that is milled out. Can anyone point me in the right direction to have the logo area left raised for me to v carve logo onto it?
Last edited by Hali on Mon Jan 28, 2019 7:03 pm, edited 1 time in total.
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: adding logo to design & make plaque
These two videos should give you what you need:
http://support.vectric.com/tutorials/V9 ... ideo_id=50
http://support.vectric.com/tutorials/V9 ... ideo_id=74
http://support.vectric.com/tutorials/V9 ... ideo_id=50
http://support.vectric.com/tutorials/V9 ... ideo_id=74
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: adding logo to design & make plaque
A picture would help. If you don't want a section of a component machined draw a closed vector around the area then in the Roughing/Finishing toolpath use Selected Vector(s) under Machining Limit Boundary.
John
Maker of Chips
Maker of Chips
Re: adding logo to design & make plaque
Sorry, Here is a picture. The 2 logos on each side of jersey are what I am having trouble with
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: adding logo to design & make plaque
Should be the same as the text you've added. Create the v-carve toolpath and make sure the Project onto 3D is checked.
Re: adding logo to design & make plaque
Thank you so much Adrian, it was the project onto 3d that I was missing. Wow I should have asked for help hours ago.
Re: adding logo to design & make plaque
How would I make them into 3D to match the other items?
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: adding logo to design & make plaque
You can't with VCarve. You would need Aspire to make 3D items from scratch.
Re: adding logo to design & make plaque
Thanks again