First attempt at carving a model

This forum is for general discussion regarding VCarve Pro
cusoak
Vectric Wizard
Posts: 486
Joined: Mon Nov 06, 2017 1:57 pm
Model of CNC Machine: Shapeoko 3D XXL

Re: First attempt at carving a model

Post by cusoak »

Ok Thanks I found it.
Jeff

cusoak
Vectric Wizard
Posts: 486
Joined: Mon Nov 06, 2017 1:57 pm
Model of CNC Machine: Shapeoko 3D XXL

Re: First attempt at carving a model

Post by cusoak »

Ok I followed along with the video on the flower design and creating tool Paths.
Attached file is what I choose to try.
Could some one take a look at tell me what you think, of the tool paths and settings.
One question I have is that when I looked at the run times for the different tool paths the .25 EM was very Short , Did I choose the wrong tool. Or is that typical .
If this happens to be OK, or just need some little tweaking , That easy.
Jeff
Ps Looks like my file is to big to post
So what do I need to do to post it

User avatar
mtylerfl
Vectric Archimage
Posts: 5865
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA

Re: First attempt at carving a model

Post by mtylerfl »

Hi Jeff,

Go to DropBox.com and create a free account.

Then you can upload files to your account and copy/paste the download link to your file here
Michael Tyler

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

cusoak
Vectric Wizard
Posts: 486
Joined: Mon Nov 06, 2017 1:57 pm
Model of CNC Machine: Shapeoko 3D XXL

Re: First attempt at carving a model

Post by cusoak »

Hey thanks I will do that.

Post Reply