tap files off

This forum is for general discussion about Aspire
Post Reply
lwarnell01
Posts: 3
Joined: Sun Feb 18, 2018 7:20 am
Model of CNC Machine: Shark HD4

tap files off

Post by lwarnell01 »

Good evening I have a Shark HD CNC with bosch router and while trying to run the files for the Padlock plaque in the gallery the router doesn't line up to my Zero axis. I used the touch plate to specify the zero z axis, but when i run the project the router goes all the way to the X,Y axis limit to try to start cutting. Any ideas? I did recalculate the toolpaths.

User avatar
martin54
Vectric Archimage
Posts: 7339
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
Location: Kirkcaldy, Scotland

Re: tap files off

Post by martin54 »

Have you made sure you have the correct x,y zero set? Check the set up in the file if this is a downloaded project to ensure where your setting your x y zero is the same as in the file, also might be worth checking the starting position in the toolpath set up :lol: :lol:

Daniel S
Vectric Craftsman
Posts: 110
Joined: Thu Jan 08, 2009 6:24 am
Model of CNC Machine: CAMaster Stinger SR-23
Location: Orange, CA

Re: tap files off

Post by Daniel S »

Are you using the Pendant? If so use the down button to see your xyz start position for current project.

Post Reply