Greolt wrote:Can't think of a way to rapid to the first cut position of the new segment before entering the new segment.
You won't know that first cut position until you enter that new segment.
You really need a "begin FIRST_PLUNGE_MOVE" command, which I am fairly certain, does not exist.
Is your touch off slow? Is this what annoys you?
Mine is fairly quick. Doesn't bother me at all.
Maybe you can streamline it a bit.
ger21 wrote:There is indeed a "First Plunge Move".
See the Post Processor manual.
Mobius wrote:That way I could theoretically group a couple of the 5x4 sections together under the same toolpath, and only touch off 25 times instead of 3000.
Mark wrote:Hello Mobius,
You should be able to achieve what you are trying to do by adding an "INITIAL_RAPID_MOVE" section
and adding the commands for your G28.1 zeroing process as the first line of this section and the standard
line from the existing "RAPID_MOVE" section below this.
I hope that this helps.
Greolt wrote:Wow that is a lot of starts. When I cut a full sheet of decorative parts, it would never get above 100.
Users browsing this forum: No registered users and 1 guest