Message box
"The procedure entry point GetLogicalProcessorInformation could not be found in the dynamic link library KERNEL32.DLL"
Meanwhile, 8.5 and all others have been running just fine on same machine.
What's the problem?
9.5 fails to start
- Rcnewcomb
- Vectric Archimage
- Posts: 5915
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: 9.5 fails to start
Try reinstalling 9.5
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- BrianM
- Vectric Staff
- Posts: 1964
- Joined: Mon May 16, 2005 10:15 am
- Model of CNC Machine: A few ...
- Location: Alcester U.K
- Contact:
Re: 9.5 fails to start
Are you running XP? This error occurs if service pack 3 isn’t installed. For V9, XP must have service pack 3 (sp3) installed.
Brian
Brian