Hi
I have been trying to make a piece of molding for a table.
The problem is not with the profile.
The problem is that I get about a 1/4 inch piece at the end of the piece.
I have tried everything, I then checked the simulation and it is also on the simulation.
I have attached the file, it is called TableProfile12.crv
Any help would be greatly appreciated as I'm trying to make the profile for a friend's son and
he would like it done before Thanksgiving.
Thank you.
Harvey
Help with molding toolpath
-
- Vectric Apprentice
- Posts: 96
- Joined: Sun Sep 06, 2015 2:49 am
- Model of CNC Machine: Shark HD3
Help with molding toolpath
- Attachments
-
- TableProfile12.crv
- This is the file
- (510.5 KiB) Downloaded 92 times
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Help with molding toolpath
Us a Boundary Offset just a little larger than half the diameter of the finish ball nose. I used .13"
John
Maker of Chips
Maker of Chips
-
- Vectric Apprentice
- Posts: 96
- Joined: Sun Sep 06, 2015 2:49 am
- Model of CNC Machine: Shark HD3
Re: Help with molding toolpath
Thank you, thank you and thank you.
It worked just like you said it would.
I spent all day making test cuts and I could not figure it out.
Harvey
It worked just like you said it would.
I spent all day making test cuts and I could not figure it out.
Harvey