New grips for my Sig P938.
Double sided carve with alignment pins; eight tool paths. 84 minutes to cut.
Very little sanding off the machine, natural Minwax stain, 3 coats Rustolium Triple Thick poly finish.
Sapele grips
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Sapele grips
Very nice! Did you create the model?
I've been wanting to make a pair for my PM9
Thanks for sharing.
I've been wanting to make a pair for my PM9
Thanks for sharing.
John
Maker of Chips
Maker of Chips
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Sapele grips
Thanks.
Yes, basically a two-rail sweep with a tilt to make the butt end thicker.
Grips for a PM9 would be a challenge. I have a CM9 and it looks like most of the grip is molded into the frame--no removable scales.
Yes, basically a two-rail sweep with a tilt to make the butt end thicker.
Grips for a PM9 would be a challenge. I have a CM9 and it looks like most of the grip is molded into the frame--no removable scales.
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Sapele grips
Mike,
You're right I forgot about that, oh well I like my PM9 anyway....
You're right I forgot about that, oh well I like my PM9 anyway....
John
Maker of Chips
Maker of Chips
- Xxray
- Vectric Wizard
- Posts: 2304
- Joined: Thu Feb 17, 2011 8:47 am
- Model of CNC Machine: CAMaster Stinger 1
- Location: MI USA
Re: Sapele grips
Nice work.
Yep, most firearms these days from what I have seen use molded grips.
Yep, most firearms these days from what I have seen use molded grips.
Doug
- Creation in Wood
- Vectric Wizard
- Posts: 856
- Joined: Thu May 28, 2015 8:58 pm
- Model of CNC Machine: Legacy Maverick ATC 4x8 CNC
- Location: Monument, Colorado USA
-
- Posts: 12
- Joined: Tue Jan 11, 2011 4:41 pm
- Model of CNC Machine: Avid CNC Pro 4824
- Location: Mid Missouri
Re: Sapele grips
Nice work! I'm a big fan of the P238 for cc.
- SteveNelson46
- Vectric Wizard
- Posts: 2310
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.
Re: Sapele grips
Mine came from the factory with real rosewood grips. They are so pretty I just didn't want to mess with them.
Steve