Post general information and questions relating to Cut2D in this Forum.
I was hoping somebody could assist me - I am making a sign out of White Oak , setup and tool selection is good and the sign is able to be cut - the problem is my safe Z seems to be an issue. When the Z axis lifts to move to the next letter or shape it moves before the Z axis is out of the way... cutting a groove into the material. Has anyone had this before? Is my feed rate too fast?
- Posts: 1
- Joined: Sun Mar 04, 2018 7:09 am
- Model of CNC Machine: x carve generic - GRBL
I see no-one has chipped in to your post so I thought I would start things off.
It's difficult trying to best guess what your doing so lets start with some fundamentals before we get into 'hardware' issues.
Job Set-up - Zero face or bed? Then did you?
Material Set-up - Z1, Z2 & Home Z
Toolpath Setup - Start Depth (Flat Depth and/or Cut Depth)
You mentioned feed speed. Check it here - if in doubt 'slow down'
Post processor - Correct for machine, Correct units.
When you've checked all the 'set-ups'. If it still happens - is it repeatable?
Anyway that’s my two penn'orth
I'll watch with interest
Sincerely and in good faith
- Vectric Apprentice
- Posts: 90
- Joined: Wed May 18, 2016 6:00 pm
- Location: Lancashire UK
- Model of CNC Machine: Shopbot
Return to Cut2D - General
Who is online
Users browsing this forum: No registered users and 5 guests