Clock

An area to upload images of pieces cut using VCarve Pro

Clock

Postby rgerding » Wed Nov 01, 2017 7:08 pm

Carved clock using 1/2" plywood and clock parts from Klockit. I used Varathane before carving and then used water based paint so that any paint outside the lines could be easily wiped with wet cloth.
Attachments
fourth street.jpg
User avatar
rgerding
 
Posts: 21
Joined: Mon Nov 28, 2016 7:29 pm
Model of CNC Machine: Iconic 2015

Re: Clock

Postby dwilli9013 » Wed Nov 01, 2017 7:10 pm

Nice work. Thanks for sharing.
D-Dub
Dwayne
Dwilli
User avatar
dwilli9013
Vectric Wizard
 
Posts: 831
Joined: Mon Sep 30, 2013 12:45 am
Location: Machesney Park Illinois
Model of CNC Machine: 3 axis Self Designed Self Built

Re: Clock

Postby MTSO » Wed Nov 01, 2017 7:31 pm

Mate, that looks great. I have always wanted to make a nice clock. So you are saying that you sealed the plywood with a gloss coat before machining
to allow you to be able to wipe the paint away when required. Did that also prevent the paint from seeping through the wood as it sometimes does?.

regards

Brian
MTSO
Vectric Craftsman
 
Posts: 214
Joined: Tue Mar 11, 2014 6:12 pm
Location: Auckland New Zealand
Model of CNC Machine: salecnc XJ1224

Re: Clock

Postby rgerding » Thu Nov 02, 2017 12:25 am

Yes, as you can see, the paint does not seep.
User avatar
rgerding
 
Posts: 21
Joined: Mon Nov 28, 2016 7:29 pm
Model of CNC Machine: Iconic 2015

Re: Clock

Postby GEdward » Mon Nov 06, 2017 3:45 pm

When using the seal first technique as described above I have had some bleeding when painting/staining the carved features when using soft porous woods like aspen. What I now do in anticipation of that problem is to spray an additional coat of polyurethane or lacquer over the entire project after the carve. I wrap a flat block of scrap wood with a paper towel to wipe off any paint or stain that ends up outside of the desired area. That way the wiping process does not reach into the carved area and wick out too much of the paint. It leaves a nice crisp border.
GEdward
Vectric Apprentice
 
Posts: 18
Joined: Wed Jul 05, 2017 9:13 pm
Model of CNC Machine: Romaxx WD-1

Re: Clock

Postby GWDawg1 » Fri Nov 10, 2017 2:40 am

Great work!!
GWDawg1
 
Posts: 9
Joined: Tue Oct 24, 2017 2:08 am
Model of CNC Machine: Shark


Return to VCarve - Gallery

Who is online

Users browsing this forum: No registered users and 7 guests