Quick engrave problem

Post general information and questions relating to Cut2D in this Forum.

Quick engrave problem

Postby dwalsh103 » Fri Oct 27, 2017 3:22 am

I am using the quick engrave tool using Fill and offsets.

I have noticed that occasionally it will not lift up the tool when moving to a different spot. It will cut across several lines. It appears that after it engraves the middle offset, it does not lift up moving to the next vector.

Any ideas?

I originally tried to use the Fill with crosshatch, but that took to long and was too hard on my machine. The offset fill runs much faster and I like the effect.

I am using a diamond drag bit on acrylic to make a lighted LED sign.

Angel1.jpg
dwalsh103
 
Posts: 1
Joined: Wed Feb 24, 2016 4:46 am
Model of CNC Machine: Home built

Re: Quick engrave problem

Postby Xxray » Sat Nov 18, 2017 5:14 am

Might be caused by the tool itself having too much spring pressure [adjustable on most drag bits].
Also may try setting z clearance in material setup to .2 or so to be certain the bit is getting proper clearance.
If it still drags where its not supposed to then you have a vector problem and need to diagnose or try making new vectors.

You can also use a plain pocket toolpath, just select an engraving bit with appropriate depth [I usually go very shallow on acrylic, .009 or so, just a scratch]
Doug
User avatar
Xxray
Vectric Wizard
 
Posts: 1663
Joined: Thu Feb 17, 2011 8:47 am
Location: MI USA
Model of CNC Machine: CAMaster Stinger 1


Return to Cut2D - General

Who is online

Users browsing this forum: No registered users and 4 guests