Chris, I have attempted to follow your instructions to add tape splitting support to the CNCShark-USB arc pp supplied with my Vectric software. Will this work?
Wayne K
Splitting a toolpath?
-
- Posts: 2
- Joined: Sat Apr 29, 2017 7:31 am
- Model of CNC Machine: Nexrwave CNC Shark Limited Edition
Re: Splitting a toolpath?
- Attachments
-
- CNCShark TS1000-USB_Arcs_inch.pp
- CNCShark pp with tape splitting
- (6.12 KiB) Downloaded 201 times
-
- Posts: 2
- Joined: Sat Apr 29, 2017 7:31 am
- Model of CNC Machine: Nexrwave CNC Shark Limited Edition
Re: Splitting rougin toolpaths using different bits?
All, in Aspire can I reduce the overall length of a single machine run in 3D carving by running multiple roughing toolpaths with progressively finer bits, e.g. run the first roughin toolpath with a 1/2" end mill, then a second roughin toolpath with a 1/8" ball nose bit? I have tried this but it seems to me that aspire does not remember the profile of the first roughin cut when doing the second roughin cut?
I hope one of the Vectric experts will provide guidance on this?
WayneK
I hope one of the Vectric experts will provide guidance on this?
WayneK