Frankenswitch instructions and files.

An area to upload images of pieces cut using VCarve Pro
User avatar
highpockets
Vectric Wizard
Posts: 3667
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: Frankenswitch instructions and files.

Post by highpockets »

Looks good Rich.

I did learn one thing with in the first week of installing my grandson's switch. Little boy's can be rough on things :D :D :D The #8 screw holding the handle on was not enough. I took it back to the shop, drilled a 1/2" hole halfway through the bar the handle attaches to. Made a new handle with a base just a little longer so it would fit into the 1/2" hole. Glued the new handle into the hole in the crossbar and put the #8 screw back it. I'm not going to challenge him to break it again, but it will take him a bit longer next time :D :D :D
John
Maker of Chips

Post Reply