First Attempt with the Diamond Drag Bit
-
- Vectric Craftsman
- Posts: 214
- Joined: Thu Nov 21, 2013 9:10 pm
- Model of CNC Machine: Laguna IQ
- Location: York, SC
First Attempt with the Diamond Drag Bit
Ok, here is my first attempt with the diamond drag bit. I made a few adjustments that I think will make the next project much better. Increased the spring pressure in the bit and will decrease the stepover. Overall I am pretty satisfied with the results.
- ohiolyons
- Vectric Wizard
- Posts: 1710
- Joined: Wed May 27, 2009 7:16 pm
- Model of CNC Machine: Laguna IQ
- Location: Kettering, Ohio
Re: First Attempt with the Diamond Drag Bit
thanks for sharing
Is there any prep you have to do to the stone? Some type of lubricant?
Is there any prep you have to do to the stone? Some type of lubricant?
John Lyons
CNC in Kettering, Ohio
CNC in Kettering, Ohio
-
- Vectric Craftsman
- Posts: 214
- Joined: Thu Nov 21, 2013 9:10 pm
- Model of CNC Machine: Laguna IQ
- Location: York, SC
Re: First Attempt with the Diamond Drag Bit
I did not add any coolant, but since I finished this one I have seen online where some people have added water to the surface.