Hi, I have been running the above combination for about two years with no problems but recently I have experienced trouble when I attempt to Reference the machine..... In a nutshell the machine will not reference.
I can run the machine ignoring referencing just ensuring that the job is located correctly on the worktable.
I have contacted the WinPC with less than satisfactory results.
Any ideas? I have not, as yet reinstalled the software Is it possible that a file in the software has been corrupted or what any advice would be greatly appreciated
Problem solved.... you were entirely correct.... One of the magnets had come quite loose ..... its only held on with one plastic allen screw and vibration must have loosened it. The biggest problem was getting the screw back into position... however, I borrowed one of those cheap mirrors on a stick and after a lot of messing about managed to reposition it. Referenced immediately.
You have no idea how much time I have wasted with this referencing problem
Not entirely satisfied with the way the thing is held onto the machine ..... in my opinion nothing to stop it happening again.