Hello Vectric family,
I hope that you are all doing fine. Kindly seeking for a source where i can get Tabernacle Table or Chalice for CNC engraving.
Any help is Most appreciated in advance.
Kind regards
Jane
Tarbernacle Table or Chalice.
-
- Vectric Craftsman
- Posts: 201
- Joined: Fri Oct 31, 2014 8:14 am
- Model of CNC Machine: TS1325
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Tarbernacle Table or Chalice.
You can make your own Chalice with the new Turn & Spin feature.
-
- Vectric Craftsman
- Posts: 201
- Joined: Fri Oct 31, 2014 8:14 am
- Model of CNC Machine: TS1325
Re: Tarbernacle Table or Chalice.
Mike-S wrote:You can make your own Chalice with the new Turn & Spin feature.
Good morning Mike,
Thanks for the reply, kindly i must confess that i have no idea about Turn & Spin feature. is it in the new version 9?
I would appreciate if you could tell me more about this.
Thanks
Kind regards
Jane
- mezalick
- Vectric Wizard
- Posts: 2970
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: Tarbernacle Table or Chalice.
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com
-
- Vectric Craftsman
- Posts: 201
- Joined: Fri Oct 31, 2014 8:14 am
- Model of CNC Machine: TS1325
Re: Tarbernacle Table or Chalice.
mezalick wrote:Jane,
Take a look at this
http://support.vectric.com/tutorials/V9 ... ideo_id=97
Michael
Thanks Michael